Every 400 Hours; Replacing Water Separator [Lx3310]; Changing Transmission Fluid - Kubota LX2610 Operator's Manual

EVERY 400 HOURS

1. Check air conditioner condenser to be sure it is
clean of debris.
(1) Air conditioner condenser
EVERY 400 HOURS
1. Replacing water separator
[LX3310]
This job should not be done in the field, but in a clean
environment.
1. Disconnect the water sensor connector.
2. Close the fuel shutoff-valve.
3. Unscrew the cup and remove it, then rinse the
inside with kerosene.
4. Take out the element and replace it with a new one.
5. After replacing, reassemble the water separator,
keeping out dust and dirt.
6. Connect the water sensor connector.
7. Bleed the fuel system.
(See Bleeding fuel system on page 136.)
(1) Water sensor connector
(2) Fuel shutoff-valve
(3) Cup
(4) Element
IMPORTANT :
• If the water separator and/or fuel filter is not
well maintained, the supply pump and
LX2610,LX3310
(A) "CLOSE"
injector may be damaged earlier than
expected.

2. Changing transmission fluid

WARNING
To avoid personal injury or death:
• Allow the engine to cool down sufficiently; oil
can be hot and can burn.
1. To drain the used oil, remove the drain plug at the
bottom of the transmission case and drain the oil
completely into the oil pan.
2. After draining reinstall the drain plug.
3. Fill with new KUBOTA SUPER UDT fluid up to the
upper notch on the dipstick.
(See LUBRICANTS, FUEL AND COOLANT on
page 106.)
4. After running the engine for a few minutes, stop it
and check the oil level again; add oil to prescribed
level.
PERIODIC SERVICE
127