Table of Contents
Advertisement
4.
Locations and Functions
4.1
Locations and functions
①
Lens mount
CCD sensor
12-pin connector
D-sub 9 pin connector
RJ-45
LED
LED
Holes for RJ-45 thumbscrews
Holes for RJ-45 thumbscrews
Mounting holes
*1) Note:
Rear protrusion on C-mount lens must be less than 10.0mm.
*2) Note:
When an RJ-45 cable with thumbscrews is connected to the camera, please do
not excessively tighten screws by using a screw driver. The RJ-45 receptacle on
the camera might be damaged.
For security, the strength to tighten screws is less than 0.291 Newton meter
(Nm). Tightening by hand is sufficient in order to achieve this.
*3) Note:
The tripod adapter plate MP-41 can be used with BM/BB-500GE
BM-500GE / BB-500GE
⑩
②
C-mount (Note *1)
2/3 inch CCD sensor
DC +12V power and GPIO interface
Auxiliary GPIO interface (LVDS IN and TTL IN/OUT)
GigE Vision I/F. Accepts connector w thumbscrews.
GigE Network condition: LINK
GigE Network condition: ACT
Vertical type (above and below RJ-45).
Horizontal type (left and right of RJ-45) (Note *2)
M3 depth 5 mm for tripod mount plate (Note *3)
Fig. 1. Locations
④
10
③
D CIN/ T R IG
P O W E R/ TR IG
⑥
LINK
A C T.
⑦
G igE
⑤
⑧ ⑨
Advertisement
Table of Contents
