Installation And Start-Up; Package; Mounting - Dantherm SSC-01 Service Manual

Installation and start-up

2. Installation and start-up 安装和启动
This section describes the procedure from unpacking to start-up.

Package

The unit can be delivered in different packages depending on shipping method,
but the most common solution is each unit is wrapped with film and protected
with paper corners. If that is the case, the film should carefully be cut open with
a cutting tool.
Contents in The SSC-01 is delivered with an installation kit with the following content:
the package
Quantity
SSC-01
Tools For installation:

Mounting

Mounting The mounting procedure of the air condition unit should follow below steps:
procedure
安 装 和 启 动 安 装 和 启 动
安 装 和 启 动 安 装 和 启 动
包 装 包 装 包 装 包 装
Unit
1 Pcs.
1 Pcs.
1 Pcs,
DC power supply (48VDC)
•
Small screwdriver
•
装 配 装 配 装 配 装 配
1. Demount the package and mounting bracket screws (4pcs M8&M4).
2. Mount the unit on the chosen wall with 14 M5 screws with washers.
3. Mount the frame and door with M4 screws.
4. Connect the power cable and connector.
1.
2. 14 M5
3. M4
4.
Item description
SSC-01
Service manual
Rejection sheet metal
.
4 M8 M4
Page 6 of 26