Dantherm SSC-01 Service Manual page 22

Replacement of spare parts
Step
步 骤 步 骤 步 骤 步 骤
1
2
3
4
5
Step I
更 换 部 分 零 件 更 换 部 分 零 件
更 换 部 分 零 件 更 换 部 分 零 件
Make sure that the power to the unit is safely switched off.
Remove service cap and disconnect all cables mounted on the control
board. Pay attention to note the number relating to the control board
pins. (stepI)
1
Unscrew the 4 machine screws on the controller supporter and pull it
out. Unscrew the 4 machine screws (M3) fixing the control board.
Pay attention to the screws and nylon distance washer so it is not lost.
(stepII)
Replace the control board with the new one by fixing it with the 4
screws (M3) on the nylon distance washers.
Reconnect all cables according to front notes.
1
Page 22 of 26
Action
行 动 行 动 行 动 行 动
4
( 2)
4 M3
Controller
supporter
service cap
Step II
4
2