Chapter 2 Release Considerations; Oms-V 2.3 Mr1 Installation Instructions - Nortel V2.3 Release Note

Chapter 2 Release Considerations

The following table lists the latest software loads for the products shown:

OMS-V 2.3 MR1 Installation Instructions

For OMS-V 2.2.2 and onward, installation was simplified by creating a single
command to do both the removal of an old installation and adding the new
installation in a single script. This continues in OMS-V 2.3 MR1. Installers of
OMS-V are no longer required to do extra UNIX steps.
The following set of files are now delivered for each release.
•
•
•
•
•
The script, omsvupgrade, must be used to install OMS-V 2.3 MR1. At the
completion of the execution of the omsvupgrade script, you will be requested
to edit the vsm configuration file, and launch the daemons using ovstart. Full
installation instructions are included in the NTP 241-9501-200, Vector
Software Installation and Commissioning.
Note: Always be sure to use the version of the omsvupgrade script which you
receive with each release since omsvupgrade may change from one release to
another.
Magellan Vector OMS-V 2.3 Release Notes
Product Release
Table 3:
Product
VSS VSS2.3.2_300_98.tar
AS VSS1.1.0_AS10_210_97
OMS-V <to be determined>
MDP mdp10.6
the OMS-V HP-UX and Solaris tar files for the loads listed in the table
above
the release notes (this document)
NTP 241-9501-200, Vector Software Installation and Commissioning
shareLib.sh (upgrade script)
omsvupgrade (upgrade script)
List
Software Load
12