Nortel V1 Release Note
Nortel V1 Release Note

Nortel V1 Release Note

Nortel v1 software: release note

Advertisement

Magellan Vector 1.1

Release Notes

Post Gate 3 - Release Number 8
Software Release Date: April 30, 1998
Issue: 1.11
© 1996 Northern Telecom
All rights reserved
*Magellan is a trademark of Northern Telecom
Printed in Canada

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the V1 and is the answer not in the manual?

Questions and answers

Summary of Contents for Nortel V1

  • Page 1: Release Notes

    Magellan Vector 1.1 Release Notes Post Gate 3 - Release Number 8 Software Release Date: April 30, 1998 Issue: 1.11 © 1996 Northern Telecom All rights reserved *Magellan is a trademark of Northern Telecom Printed in Canada...
  • Page 2: Revision Record

    Revision Record Issue Date 96 03 15 96 04 30 96 05 17 96 06 28 96 08 08 96 08 27 96 10 11 1.10 97 11 07 1.11 98 04 30 Purpose Initial Release Lab Trial (Pre-gate 2) Gate 2 Gate 3 Post Gate 3 Release Number 1...
  • Page 3 Contents Introduction1 Product Release Table 1 Chapter 2 New VMI Commands Vector Software Resolved Issues Contents iii Magellan Vector 1.1 Release Notes...
  • Page 4 iv Contents Magellan Vector 1.1 Release Notes...
  • Page 5: Chapter 1 Introduction

    Chapter 1 Introduction This version of the release notes highlights the software changes which have been included in the Vector Switch Software (VSS) and the Vector System Manager (VSM) since Vector 1.1 Gate 3. This is an addendum to the release notes provided with the Gate 3 load.
  • Page 6 2 Chapter 1 Magellan Vector 1.1 Release Notes...
  • Page 7: Chapter 2 Vector Software Resolved Issues

    Chapter 2 Vector Software Resolved Issues The following is the list of items which have been resolved in this (No. 8) 1.1 Post Gate 3 release. Priority Serv. No Request Title major 10139980 Unable to time the Vector Access Shelf using a DS3 connection This SR resolves the problem of the DS3 Network Module not providing stable line timing when the timing source was imported from the switch backplane (i.e.
  • Page 8 At most a hundred (100) entries will be stored in every 10 seconds interval and displayed as follows on the debug port as well as the serial port. asxd: INFO: oamPT cells found in last 10 seconds: Fri Nov 7 12:48:48 1997 asxd: INFO: ( 1) oamPT cell found on Output Port: CTL, VP 0, VC 34 asxd:...
  • Page 9 Chapter 2 Vector Software Resolved Issues 5 This command resets the Total and Delta values of the selected counter to zero (0). The ’all’ resets both counters. Magellan Vector 1.1 Release Notes...
  • Page 10 Magellan Vector 1.1 Release Notes...

Table of Contents