Nortel Express Call Center Installation Manual page 24

Media Card
5 To specify a subnet mask, at the command prompt, type
lnIsa_writeSubnetMask "<aaa.bbb.ccc.ddd>", and then press Enter.
Note: Do not include the < and > symbols as part of the input. The
quotation marks are required.
6 To specify a default gateway (optional), at the > prompt, type
lnIsa_writeGW "<aaa.bbb.ccc.ddd>", and then press Enter.
Note: Do not include the < and > symbols as part of the input. The
quotation marks are required.
7 To turn off maintenance mode, at the command prompt, type
maintModeOff.
8 To make the changes take effect, at the command prompt, type
sysReboot, or press Reset on the faceplate.
Note: If the IP address is not unique, the following message appears on the
terminal attached to the faceplate connector: 0x12c3f84 (tNetTask)
duplicate IP address '<hex value>' sent from Ethernet
address <address>. If this message appears, you must assign another
address.
9 You know that the card has completed restarting when the following
message appears: Waiting for DSPM to initialize.
10 Press Enter to get the logon prompt.
11 Choose Call ➝ Disconnect to end the HyperTerminal session.
Note: The network details and RAM appear in the system restart
information. To see an example of a system restart, refer to Appendix A,
"System restart example."
To check the IP address
1 Log on as user vpsdseuser with password welcome2vp.
2 Type hostShow, and then press Enter.
Result: The card's IP address appears.
Although the Media Card is located on the ELAN network, it is possible to
administer files and directories from a client CLAN connection through the
Symposium Express Call Center client application. This facility is part of the
Voice Services or Media Card client application. When a voice services
24
Standard 2.0
Symposium Express Call Center