Download Print this page

Specifications - Kärcher SP 16.000 Dual Manual

Hide thumbs Also See for SP 16.000 Dual:

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 9
Fault
The pump does not start
up, or stops suddenly
during operation
The pumping capacity
decreases
The delivery rate is too
low
Quick-Connect cannot
be opened or closed
The filter basket cannot
be moved
Electrical connection
Mains voltage
Power frequency
Nominal power
Device performance data
Flow rate (max.)
Pressure (max.)
Delivery head (max.)
Immersion depth (max.)
Particle size (max.) of permissible feed fluids
Automatic mode
Switch-on height of float switch (locking in uppermost
position)
Switch-off height of float switch (locking in uppermost
position)
Switch-on height of float switch (locking in lowermost po-
sition)
Switch-off height of float switch (locking in lowermost po-
sition)
Manual operation
Minimum fluid height for waste water and clear water de-
livery
Residual fluid height for waste water and clear water de-
livery
Minimum fluid height for flat vacuuming
Residual fluid height for flat vacuuming
Cause
The power supply is disconnected.
The thermal protection switch has
switched off the pump because of over-
heating.
Dirt particles block the suction area.
The suction area is clogged.
The maximum delivery head is exceed-
ed.
The hose diameter and the hose length
have been selected incorrectly.
The push-fit system is dirty.
The filter basket is dirty.

Specifications

Rectification
1. Check the fuses and the electrical connec-
tions.
1. Pull the mains plug out of the socket.
2. Allow the pump to cool down.
3. Remove any dirt particles in the suction ar-
ea.
4. Clean the suction area.
5. Prevent the pump from running dry.
1. Pull the mains plug out of the socket.
2. Clean the suction area.
1. Pull the mains plug out of the socket.
2. Clean the suction area.
1. Observe the maximum delivery head, see
chapter Specifications.
2. If necessary, select a greater hose diame-
ter or a shorter hose length, see chapter
Optimising the flow rate.
1. Remove the clip.
2. Clean the clip.
3. Install the clip.
1. Loosen the latch screws using a screwdriv-
er.
2. Remove the filter basket.
3. Clean the filter basket.
4. Install the filter basket.
SP 16,000 Dual
V
230-240
Hz
50
W
550
l/h
16.000
bar
0,9
m
9
m
7
mm
20
mm
255-310
mm
115-220
mm
155-210
mm
40-120
mm
60
mm
25
mm
40
mm
1
English
13

Advertisement

loading