Configuring The Voip Gateway Time And Date; Figure 18 Regional Settings Screen - Nortel VoIP Gateway Configuration Manual

82

Configuring the VoIP Gateway time and date

Configuring the VoIP Gateway time and date
To configure the time and date on the VoIP Gateway:
1
Access the web interface.
2
Click the Advanced Configuration button.
3
Click the Regional Settings tab.
The Regional Settings screen appears.

Figure 18 Regional Settings screen

4
In the YYYY box, enter the current year (for example, 2003).
5
In the MM box, enter the number for the current month (for example, enter 5 for May).
6 In the DD box, enter the current date (for example, 25).
7 In the HH box, enter the current hour using 24 hour clock, (for example, enter 14 for 2 p.m.).
Note: The time you enter is the time at the location where the VoIP Gateway is
installed. Be sure to allow for the time difference if the VoIP Gateway is located in a
different time zone.
8
In the MM box, enter the current minutes.
9
In the SS box, enter the current seconds.
10 Click the Set Time & Date button.
11 To save the changes so they are available after a power fail, you must save the changes to
non-volatile memory. To save the changes to non-volatile memory:
P0606298 02