Changing The Password; Accessing A Board In The Cli - Nortel Passport 8250 Command Line Interface Manual

Nortel passport 8250 integrated access mux: user guide

Hide thumbs Also See for Passport 8250:

Table of Contents

24 Chapter 2 Getting started with the CLI

Example

The following is an example of logging into the CLI for the ﬁrst time and

setting the password to 1h6d833eR.

Changing the password

The passwd command changes the password.

Example

The following is an example of changing the password from 1h6d833eR to

jtF85dW4

You monitor and conﬁgure the Passport 8250 device by accessing the boards

on the Passport 8250 device. To access a speciﬁc board, type the slot number

for the board at the CLI prompt. The CLI prompt changes to display the

current board number.

For the boards available on the Passport 8250 device and the slot numbers for

the board, see "Boards and slot numbers" (page 25).

241-5101-201 R2.2

Letters and numbers can be used.

username: admin

password: 1h6d833eR

Note: If you forget the password, contact your Nortel Networks

representative to reset the password.

Change the password:

passwd

[Edgeplex CLI]: passwd

enter current passwd: 1h6d833eR

please enter new password: jtF85dW4

confirm new password - please re-enter: jtF85dW4

password has been changed

Table of Contents