Table of Contents
Advertisement
Viewing entries in the fault log
The faultlogview command displays entries in the fault log.The syntax of the
command is:
faultlogview [<entry#>]
where
[<entry#>]
Note: Entering the faultlogview command without the [<entry#>]
parameter displays all the fault log entries.
Procedure
1
Display the entries in the fault log:
faultlogview [<entry#>]
Example
The following is an example of displaying the entries in the fault log. There
are three entries.
[Edgeplex CLI]: faultlogview
Entry 1: TimeStamp (0d: 0h: 1m:11s), Board (1), Fault
Id (7)
Entry
Machine Check
Entry 3: TimeStamp (0d: 0h: 3m:10s), Board (1), Fault
Id (4)
Example
The following is an example of displaying the most recent fault that was
generated from the system.
[Edgeplex CLI]: faultlogview 1
Entry #
Time stamp
Board #
Machine check exception number
Offending task
Program counter register
Data access register
Data storage interrupt status register : 0x0001812b
Machine status register
Chapter 4 Other activities in the CLI 61
is an entry number between 1 and 24 in the fault log
2: TimeStamp (0d: 0h: 0m: 0s), Board (1),
Passport 8250 Command Line Interface Guide R2.2
: 1
: 0d: 0h: 0m: 0s
: 1
: 512
: "tWdbTask"
: 0x000fa3a8
: 0x203e6f14
: 0x00009020
Advertisement
Table of Contents
