Table of Contents
Advertisement
18
Connecting the cables to the VoIP Gateway
Connecting the cables to the VoIP Gateway
Danger: Electrical shock hazard
Read and follow installation instructions carefully.
Only qualified service personnel may install this equipment.
1
Connect a 2-wire line cord to one of the RJ-11 connectors on the rear of the VoIP Gateway.
Figure 5
shows the connections on the rear of the VoIP Gateway.
2
Connect the other end of the line cord to an analog trunk port on the Norstar system.
The line cord you use must be less than 3,000 m (10,000 ft.) using regular 24 AWG line cord.
3
Repeat steps
4
Insert the RJ-45 connector on the Ethernet cable to the RJ-45 socket on the rear of the VoIP
Gateway.
5
Connect the other end of the Ethernet cable to your LAN.
Figure 5 VoIP Gateway rear panel connectors
Figure 6 RJ-45 LAN and RJ-11 port connectors and pinouts
RJ-45 connector and pinout
P0606297 02
1
and
2
for each port you are using.
Power supply
10/100 Base-T
socket
RJ-45 port
1 - Tx+
2 - Tx-
3 - Rx+
6 - Rx-
4, 5, 7, 8 - Not connected
4 RJ-11
RS-232
ports
port
RJ-11 connector and pinout
1 - Not connected
2 - Tip
3 - Ring
4 - Not connected
- Quick Links:
- Figure 1 to Set up the...
Hide quick links:
Advertisement
Table of Contents
