Table of Contents
Advertisement
Selecting a MAC address
The MAC address is displayed by a menu selection accessible when the SCP
board is reset or on a power-up. The following procedure provides changes to
NTP 241-9501-501, Vector Switch Hardware Maintenance Guide, chapter 4,
"Fabric Shelf".
Selecting a MAC address
1
As the diagnostics run, depress the next switch
2
When "FLASH?" is displayed, depress the next switch until "OPTIONS" is
displayed.
3
Depress the select switch to select "OPTIONS"
4
"MAC address?" will be displayed.
5
Depress the select switch again to select "MAC Address?"
6
The MAC address will be scrolled repeatedly on the screen
7
Depressing Next switch will return you to the main menu and display "FLASH?"
Removing and installing high-speed interconnect (HSI) cables
To replace an HSI cable, perform the following procedures in the order shown:
•
Removing an HSI cable
•
Installing an HSI cable
Removing an HSI cable
Tools and equipment required:
•
wire cutters or side cutting pliers
1
At the cable guides on the fabric shelf fan filter, cut and remove the tie wrap that
holds the HSI cables together.
2
Cut and remove the tie wraps that hold the HSI cables together at regular
intervals along the cable route from the extension shelf to the fabric shelf.
3
Disconnect the HSI cable from the link select card on the extension shelf.
4
Disconnect the HSI cable from the link module on the fabric shelf.
5
At the back of the switch frame, carefully pull the cable out from the fabric shelf
through the cable management tray.
CAUTION
Make sure that you perform the next two steps in the order listed.
Magellan Vector 2.0 Release Notes, Issue 1.9.1
21
Advertisement
Table of Contents
