Table of Contents
Advertisement
Message
Empty battery
Wrong PIN code
No drive
Wheel motor overloaded,
left/right
Collision sensor problem
Charging station blocked
1886 - 001 - 01.02.2023
Cause
The product cannot find the charging sta-
tion.
The battery is at the end of its life cycle.
The antenna of the charging station is de-
fective.
The charging plates on the product or con-
tact plates on the charging station are de-
fective because of corrosion.
An incorrect PIN code has been entered. 5
tries are permitted, and the product is then
blocked for a period of time.
The product has got caught in something
and has been slipping.
The work area includes a steep slope.
The guide wire is not put diagonally in the
slope.
Grass or other object around the drive
wheel.
The front wheels on the product are
blocked.
The contact between the charging plates
on the product and the contact plates on
the charging station is not good. The prod-
uct has made a number of tries to charge.
An object prevents the product to enter the
charging station.
The charging station is tilted or bent.
The guide wire is not installed correctly.
There is dirt on the wheels that prevents
the product to enter the charging station.
Action
Change the position of the guide wire. Re-
To install the guide wire on page 18 .
fer to
Replace the battery. Speak to your Husq-
varna service.
Do a check if the indicator lamp in the
charging station flashes red. Refer to
cator lamp in the charging station on page
37 .
Clean the charging plates and contact
To clean the charging
plates. Refer to
plates and contact plates on page 29 . If
the problem stays speak to your Husqvar-
na service.
Enter the correct PIN code. If you do
not know the correct PIN code, go to
www.husqvarna.com to get information
about how to get the PIN code or speak
to your Husqvarna service.
Free the product and correct the cause of
problem. If it is because of wet grass, wait
until the lawn is dry before you use the
product.
Steep slopes must be isolated. Refer to
examine where to put the boundary wire
on page 13 .
Make sure that the guide wire is installed
diagonally across the slope. Refer to
put the boundary wire in a slope on page
15 .
Remove grass or object from the drive
wheel.
Free the product and correct the cause
of problem. If the problem stays speak to
your Husqvarna service.
Put the product in the charging station and
make sure that the charging plates and
contact plates are connected.
Remove the object.
Put the baseplate on level ground.
Install the guide wire correctly. Refer to
install the guide wire on page 18 .
Clean the product fully.
Troubleshooting - 33
Indi-
To
To
To
Advertisement
Table of Contents
