Table of Contents
Advertisement
Message
Stuck in charging station
Upside down
Lifted
Wheel drive problem, right/
left
Electronic problem
Loop sensor problem,
front/rear
Tilt sensor problem
Temporary problem
Invalid sub-device combi-
nation
Temporary battery prob-
lem
Safety function faulty
Charging system problem
Battery problem
Temperature restriction
Charging current too high
34 - Troubleshooting
Cause
An object prevents the product to move
out from the charging station.
There is dirt on the wheels that prevents
the product to enter the charging station.
The product is in an incorrect position, the
product is tilting too much or is upside
down.
The lift sensor has been enabled because
the product has been lifted.
Grass or other object around the drive
wheel.
Temporary electronic or firmware related
problem in the product.
Incorrect type of battery.
Temporary battery or firmware related
problem in the product.
Incorrect type of battery.
The temperature in the battery is too high
or too low to start operation.
Incorrect or defective power supply unit.
Action
Remove the object.
Clean the product fully.
Put the product in the correct position.
Make sure that the product body can move
freely around its chassis. Remove or cre-
ate an island around objects that can
cause the chassis to be lifted. If the prob-
lem stays speak to your Husqvarna serv-
ice.
Clean the wheels and around the wheels.
Restart the product. If the problem stays
speak to your Husqvarna service.
Use original batteries recommended by
the manufacturer.
Restart the product. If the problem stays
speak to your Husqvarna service.
Use original batteries recommended by
the manufacturer.
The temperature in the battery is not in its
operating limits and charging/mowing has
stopped. Charging/mowing will start when
the temperature is restored to its limits.
Restart the product. If the problem stays
speak to your Husqvarna service.
1886 - 001 - 01.02.2023
Advertisement
Table of Contents
