Table of Contents
Advertisement
3.1 Introduction - Installation
Refer to www.husqvarna.com for more information
about installation and instruction videos.
We recommend you to update the firmware before you
install the product to make sure that the product has the
latest firmware. Refer to
(Firmware over the air FOTA) on page 23 .
WARNING:
safety chapter before you install the product.
CAUTION:
installation material.
3.2 Main components for installation
The installation involves the following components:
•
A robotic lawn mower that mows the lawn
automatically.
•
A charging station, which has 3 functions:
•
To send control signals along the boundary
wire.
•
To send control signals along the guide wire
so that the product can follow the guide wire
to specific remote areas in the garden and
can find its way back to the charging station.
•
To charge the product.
•
A power supply, which is connected to the
charging station and a 100-240V power outlet.
•
Loop wire, which is laid around the work area
and around objects and plants that the product
must not run into. The loop wire is used both as
boundary wire and guide wire.
3.3 To prepare for installation
Read the installation chapter before you start the
installation. Prepare the installation carefully to make the
product operate satisfactorily.
•
Make a blueprint of the work area and include all
obstacles. This makes it easier to examine where
to put the charging station, the boundary wire and
the guide wire.
•
Make a mark on the blueprint where to put the
charging station, the boundary wire and the guide
wire.
•
Make a mark on the blueprint where the guide wire
connects to the boundary wire. Refer to
the guide wire on page 18 .
•
Fill in holes in the lawn to make the ground level.
12 - Installation
3 Installation
Download firmware over the air
Read and understand the
Use original spare parts and
To install
CAUTION:
the lawn can cause damage to the
product.
•
Make sure that the product has Wi-Fi coverage
when it is in the charging station. Refer to
Download firmware over the air (Firmware over the
air FOTA) on page 23 .
Note:
New firmware only downloads when the
product is in the charging station.
•
Make sure that you have Wi-Fi coverage in the
work area if you use the Automower
remotely. Refer to
6 .
Note:
We recommend you to have Wi-Fi
coverage in the work area. If you have Wi-Fi
coverage, you can control and make settings
for the product remotely with the Automower
Connect app. The product automatically connects
to Wi-Fi when it is in an area that has Wi-Fi
coverage.
•
Cut the grass before you install the product. Make
sure that the grass is maximum 4 cm / 1.6 in.
Note:
The first weeks after installation the sound level
when the product cuts the grass can be higher than
usual. The sound level decreases after some time.
3.4 Before the installation of the wires
You can select to attach the wires with stakes or bury
them. You can use the 2 procedures for the same work
area.
CAUTION:
in the work area, bury the boundary wire
and the guide wire to prevent them from
damage.
3.4.1 To examine where to put the charging
station
•
Keep a minimum 2 m / 6.6 ft. of free space in front
of the charging station. Refer to
to put the guide wire on page 16 .
•
Keep a minimum of 30 cm / 12 in. of free space
to the right and left of the center of the charging
station.
Holes with water in
®
Connect app
Automower
®
Connect on page
If you use a dethatcher
To examine where
1886 - 001 - 01.02.2023
®
Advertisement
Table of Contents
