Table of Contents
Advertisement
5.1 To use the ON/OFF button
WARNING:
safety chapter before you use the product.
•
Push the ON/OFF button for 3 seconds to set the
product to ON. Make sure that the LED indicator
comes on.
•
The product is ON and in power save mode if the
LED indicator flashes. Push the ON/OFF button for
3 seconds to set the product to ON.
1
2
3
4
•
Push the ON/OFF button for 3 seconds to set the
product to OFF. Make sure that the LED indicator
goes out.
5.1.1 The indicator lamp
The indicator lamps on the keypad show the operating
modes of the product, refer to
keypad on page 9 .
5.2 To start the product
1.
Push the ON/OFF button for 3 seconds.
2.
Use the keypad to enter the PIN code. Refer to
PIN code on page 23 .
3.
Select an operating mode. Refer to
modes on page 24 .
Note:
The first weeks after installation the perceived
sound level when cutting the grass may be higher than
expected. When the product has cut the grass for some
time, the perceived sound level is much lower.
5.3 Operating modes
The following operating modes are available:
Main area
•
24 - Operation
5 Operation
Read and understand the
LED indicator on the
Operating
Secondary area
•
Park
•
Park / Schedule
•
Override schedule
•
5.3.1 Main area
Main area is the standard operating mode where the
product mows and charges automatically.
5.3.1.1 To set the product to operate in Main area
This can be set in the dashboard in the app or with the
keypad on the product:
1.
Push the STOP button.
2.
Push the Play button.
3.
Push the START button.
5.3.2 Secondary area
To mow secondary areas the operating mode
Secondary area must be selected. In this mode, the
operator must move the product manually between the
main area and the secondary area. The product mows
until the battery is empty. When the battery is empty, put
the product in the charging station to charge the battery.
When the battery is charged, the product moves out
of the charging station and stops. The product is now
prepared to start operation, but needs confirmation from
the operator first.
Note:
Put the product in the charging station and
change the operating mode to
with the keypad on the product if you want to cut the
main area after the battery is charged.
5.3.2.1 To set the product to operate in Secondary area
This can be set in the dashboard in the app or with the
keypad on the product:
1.
Push the STOP button.
2.
Push the Secondary area button.
1
2
3
4
Main area in the app or
1886 - 001 - 01.02.2023
Advertisement
Table of Contents
