Advertisement
4.4) Engine start
Engine start
Page 4-6
Ed.4/January 01 2023
Step
Procedure
4
Check oil level and add oil if necessary.
The oil level should be in the upper half (between the
"50%" and the "max" mark) and should never falls below
the "min." mark of the oil dipstick. Prior to long flights oil
should be added so that the oil level reaches the "max"
mark.
Avoid oil levels exceeding the "max" mark, since excess
oil could be poured out through the venting system.
Difference between max.- and min.- mark = 0.45 litre
(0.95 liq pt). Oil consumption max 0.06 l/h (0.13 liq pt/h).
5
Re-install bayonet cap.
ENVIRONMENTAL NOTE
Protect the environment.
Do not harm the environment by spilling oil. Dispose of oil in an envi-
ronmentally friendly manner.
Non-compliance can result in serious injuries or death!
Do not start the engine if any person is near the engine.
Step
Designation
1
Fuel valve
2
Starting carb (choke)
IF
engine in operating
temperature
3
Throttle lever
4
Master switch
5
Ignition
BRP-Rotax
m WARNING
Procedure
open
activated
Then
start the engine without
choke.
set on idle position
ON
both circuits switched on
Effectivity: 912 Series
Rev. 1
Advertisement
Chapters
