General Settings; Snmp Settings; Vpn Settings; Rssh Settings - D2D FLEX 3000 Setup Manual

D2D Technologies

7. General Settings

Hostname: This box will allow you to set the name of the unit, so it shows up on the browser tab
and other places. This makes it easier to navigate if you have multiple units. The default
hostname is 'devicetype-serialnumber' (Eg: d2flex5k-123456). Valid characters are a-z (case
insensitive) 0-9, hyphen(-)and dot(.) Unit must be restarted to apply the updated hostname. The
default hostname can be re-generated by entering a blank name, then Save General Settings,
and then Restart Unit.
DNS Server: In order for the unit to see the "Outside World", this needs to be set to a valid
Domain Name Server. If you do not have or know one, you can use Googles at 8.8.8.8 or,
8.8.4.4. If DHCP is enabled, this address will be checked first, followed by a check of the DHCP
DNS address(es). Changing this value will reset DHCP network interfaces.
ASI Out Burst Mode: If enabled (default mode), all ASI outputs operate at full bandwidth (~213
MBPS). If disabled, all ASI outputs are constrained to ~53 MBPS. This option provides a
compatibility mode for receivers that cannot accept a data byte on every ASI clock.
HTTPS: Requires System Reboot on change. Use 'https://nnn.nnn.nnn.nnn' or
'nnn.nnn.nnn.nnn:443' to access the user interface if the HTTPS option is enabled.
Please contact D2D Technologies support before enabling this option.
IP Direct Output: Please contact D2D Technologies support before enabling this option.
SSH Enable: Default is disabled. Please contact D2D Support for more information.

4. SNMP Settings

If you have local SNMP, you can set this to monitor the unit remotely. MIBS are located in the Support
section of the D2Manage browser.
NOTE: If you are not using SNMP, these should always be set to a unique value that is not
"public"or "private" to avoid any outside malicious activity.

5. VPN Settings

Set this up if you use the unit on a private VPN.

6. RSSH Settings

RSSH or Restricted Secure Shell, allows you to access the browser of the unit from anywhere using our
secure servers at monitor.d2dtechnologies.com. This allows you access to the device from anywhere
that you have internet access.
9
FLEX 3000 V5.2-2301