Default Subnet: 192.168.1.150 - D2D FLEX 3000 Setup Manual

D2D Technologies
Plug a PC or Mac directly into the Ethernet port labeled "ETHERNET" on the back of the unit.

2. Default subnet: 192.168.1.150

Set your PC to the following parameters: IP address: 192.168.1.150,
Subnet Mask: 255.255.255.0, Gateway: 192.168.1.1.
The D2Flex runs the D2Manage web server used for configuration.
Use a web browser to connect to the control IP address of unit.
Default IP Address: 192.168.1.205
Default UN: admin
Default PW: admin
The following browsers are supported by the D2FLEX system:
Chrome
Firefox
Microsoft Edge
Once you type in the IP address, the username and password, you will land on the "System Status" Page.
This will display the temperatures of the main chip as the current temperature, the peak temperature, and
the "Uptime". (Amount of time that the board has been powered up).
6
FLEX 3000 V5.2-2301