Table of Contents
Advertisement
D2D Technologies
Under that, is the Dynamic PSIP (Provided that you have the Guide Feature enabled.
The VCT should be set for Terrestrial or Cable.
There are several choices for the output parameters:
Off: IP Output I disabled.
UDP: Send it out via UDP protocols.
Multicast IP: Set the destination address for whatever is receiving the stream.
UDP Port: Set the port number for the UDP broadcast.
ETH Port: Choose which port on the back of the unit that the IP is leaving from.
URL: Updated as options are changed. Custom options allowed, if supported by the protocol
(EG: &myoption=value).
SRT: Send the stream via SRT (Secure Reliable Transport). For exact instructions on how SRT works,
see the chapter titled:
Sending or Receiving SRT
Status Page Thumbnail: Creates a Thumbnail on the status page of the first service in that IP output.
Custom URL: Use this if you are sending something other than UDP or SRT such as RTMP, RTP or
Zixi.
STATUS PAGE THUMBNAIL: Displays a thumbnail of the selected program on the Status tab.
18
FLEX 3000 V5.2-2301
Advertisement
Table of Contents
