Ballard Designs SUZANNE KASLER MO584 Quick Start Manual

Sk geneva faceted desk

Download this manual

SUZANNE KASLER

BALLARD DESIGNS

PRODUCT NAME: SK Geneva Faceted Desk

ITEM NUMBER: MO584

ASSEMBLED DIMENSIONS: 31"H x 60"W x 24"D

PRODUCTS ARE NOT INTENDED

FOR COMMERCIAL USE.

UPDATED: 7-9-2020

Customer Service: 800-367-2810

Online: www.ballarddesigns.com

MADE IN CHINA

Page 1 of 4

Page 1 Customer Service: 800-367-2810 SUZANNE KASLER Online: www.ballarddesigns.com BALLARD DESIGNS PRODUCT NAME: SK Geneva Faceted Desk ITEM NUMBER: MO584 ASSEMBLED DIMENSIONS: 31”H x 60”W x 24”D PRODUCTS ARE NOT INTENDED MADE IN CHINA FOR COMMERCIAL USE. UPDATED: 7-9-2020 Page 1 of 4...
Page 2 Assemble in location for intended use. REQUIRED TOOLS: Phillips Screwdriver, Allen Wrench (included) Two person assembly suggested. Remove all parts, hardware and protective packaging from carton and arrange on a clean, level surface. Prevent accidentally discarding small parts or hardware. Retain all carton contents until assembly and installation are complete.
Page 3 STEP 1: Invert Desk Top (G) onto a padded, clean, level surface and fully open both Drawers as illustrated. Attach both Side Panels (H) using *Bolts (A,B) with Lock Washer (D) and Flat Washer (C). NOTE: Holes for installing Side Panel Bolts are accessed from inside Drawer compartments. *PREVENT DAMAGE: INSTALL LONG AND SHORT BOLTS AS ILLUSTRATED! STEP 2: Desk is equipped with Rotary Levelers under each corner.
Page 4 WALL ANCHORING HARDWARE (ANTI-TIP) Ltr. Qty. Hardware Included Large Screw Small Screw WARNING Tip-Over Hazard Bracket Serious or fatal crushing injuries can occur from a furniture tip-over Prevent tipping accidents. Anchor your furniture. Retention Belt Installation: 1. Place furniture against wall at desired location then locate and mark a Wall Stud behind unit. 2.