Related Manuals for Ballard Designs Bourdonnais Desk
Summary of Contents for Ballard Designs Bourdonnais Desk
- Page 1 Customer Service: 800-367-2810 Online: www.ballarddesigns.com PRODUCT NAME: Bourdonnais Desk ITEM NUMBER: MO201 ASSEMBLED DIMENSIONS : 30 3/8”H x 60”W x 30”D PRODUCTS ARE NOT INTENDED MADE IN CHINA FOR COMMERCIAL USE. UPDATED: 2-27-2020 Page 1 of 6...
-
Page 2: Tools Needed
Assemble in location for intended use. TOOLS NEEDED: Phillips Screwdriver, Allen Wrench (included) -Two person assembly suggested. Remove all parts, hardware and protective packaging from carton and carefully arrange on a clean, level, padded surface. NOTE: To avoid accidentally discarding small parts or hardware, retain all carton contents until Hardware Packet Stretcher... - Page 3 STEP 1: Carefully invert Top (I) onto a clean, level, padded surface. Set each Leg (H) into place with pre-drilled hole oriented toward back as illustrated below. Align holes in Leg with t-nuts embedded in Top then insert Bolts (A), Lock Washers (C) and Flat Washers (B) into all holes in the order shown. NOTE: DO NOT TIGHTEN BOLTS AT THIS STAGE OF ASSEMBLY.
- Page 4 STEP 2: Orient Stretcher (G) with stepped edge toward front of desk and angled pre-drilled holes facing up. Gently fit doweled ends into pre-drilled holes in Legs (H). Insert a Screw (D) into each angled hole and use a Phillips Screwdriver to firmly tighten and secure. NOTE: Be certain Screw pulls Stretcher tight against side of Leg.
- Page 5 DRAWER REMOVAL: If neccessary, drawers may be removed by loosening Hex Bolt on underside with Allen Wrench (E) then pulling Drawer completely out. LEVELERS: Desk is equipped with Rotary Levelers under each corner. If necessary, Desk may be adjusted by carefully lifting corner then turning Leveler clockwise/counterclockwise. Rotary Levelers Cleaning &...
-
Page 6: Installation
WALL ANCHORING HARDWARE (ANTI-TIP) Ltr. Qty. Hardware Included Large Screw Small Screw WARNING Tip-Over Hazard Bracket Serious or fatal crushing injuries can occur from a furniture tip-over Prevent tipping accidents. Anchor your furniture. Retention Belt Installation: 1. Place furniture against wall at desired location then locate and mark a Wall Stud behind unit. 2.