Miele PFD 401 Marine Operating Instructions Manual page 85

Problem
Water remains in the wash
cabinet at the end of a
programme.
(This does not apply to the
Super short programme)
Peak load cut-out
Temperature compensation
after opened door: Pro-
gramme will continue in min
Cause and remedy
Before rectifying the problem:
Switch the dishwasher off with the  button.

The filter combination in the wash cabinet is clogged.
Clean the filter combination (see "Cleaning and care").

The drain pump or the non-return valve is blocked.
Clean the drain pump or the non-return valve (see

"Problem solving guide").
The drain hose is kinked.
Remove any kinks from the drain hose.

The on-site drain siphon is blocked.
Check and clean the drain siphon.

This is not a fault!
Your energy management system has detected a peak
load in the energy supply. Some components in the
dishwasher stop operating for the duration of the peak-
load negotiation.
This is not a fault!
If the door is opened during a programme sequence and
the temperature in the wash cabinet is above 60 °C,
pressure equalisation takes place once the door is closed.
Problem solving guide
85