Increased Water Level; Interim Rinse; Resetting Parameters - Miele PFD 401 Marine Operating Instructions Manual

 Further settings

Increased water level

It is then advisable to increase the water
level when a lot of water is absorbed due to
the structure of the load items or when the
type of soiling and the process chemicals
used lead to excess foam development. The
additional volume of water depends on the
type of basket or mobile unit used, the type
of soiling and the load items.
If slightly soiled load items which absorb a
little water are being reprocessed, the water
level can be reset to the factory default
setting to save water and energy.

0,5
Increas. water
quan.
-
Set the additional volume of water by

-
tapping the symbol (lower) and
(higher). In the lowest setting, the volume
of water corresponds to the factory
default setting.
Press OK to save the setting

64
l
+ OK
+
symbol

Interim rinse

If required, an additional intermediate wash
block can be activated for selected
programmes.
You can find out which programmes support
this function in the "Programme chart".

On
Interim rinse
On
-
Activates the additional intermediate wash
block for the selected programme.
Off
-
Deactivates the additional intermediate
wash block.
Tap to select an option.


Resetting parameters

You can reset individual programmes to the
factory default settings. The programme
parameters and changed programme
names are reset.
Reset programme parameters?
Yes
Yes
Select to reset the parameters and

programme names to the factory default
settings.
No
Select to cancel the process.

Off
No