Remote Commander Rm-95 - Sony EVI-HD7V Service Manual

2-1-5. Remote Commander RM-95

The remote commander RM-95 is used for changing the calculation coeffi cient in signal processing, EVR
data, etc. The remote commander RM-95 performs bi-directional communication with the unit. The
resultant data of this bi-directional communication is written in the non-volatile memory.
1. Using the remote commander RM-95
1) Connect the remote commander RM-95 to the LANC terminal with HD camera image producing tool.
2) Adjust the HOLD switch of the remote commander RM-95 to "HOLD" (SERVICE position).
If it has been properly connected, the LCD on the remote commander RM-95 will display as shown
in fi gure.
    
Page
3) Operate the remote commander RM-95 as follows.
. Changing the page
The page increases when the EDIT SEARCH + button is pressed, and decreases when the EDIT
SEARCH _ button is pressed. There are altogether 16 pages, from 0 to F.
Hexadecimal 0 1
notation
LCD Display
 
Decimal notation 0 1
conversion value
. Changing the address
The address increases when the FF (
button is pressed. There are altogether 256 addresses, from 00 to FF.
. Changing the data (Data setting)
The data increases when the PLAY ( ) button is pressed, and decreases when the STOP ( ) button
is pressed.
There are altogether 256 data, from 00 to FF.
. Writing the adjustment data
The PAUSE button must be pressed to write the adjustment data (A, D, F , 63 to 6F pages) in the
nonvolatile memory.
(The new adjustment data will not be recorded in the nonvolatile memory if this step is not per formed.)
4) Select page: 0, address: 01, and set the data to 01, and enables A, D, F , 63 to 6F pages to be adjusted.
5) After completing all adjustments, set data: 00 to page: 0, address: 01 and turn off the main power
supply once.
2. Precautions upon using the remote commander RM-95
Mishandling of the remote commander RM-95 may erase the correct adjustment data at times. To prevent
this, it is recommended that all adjustment data be noted down before beginning adjustments and new
adjustment data after each adjustment.
2-6
Data Address
2 3 4 5 6
    
2 3 4 5 6
) button is pressed, and decreases when the REW (
7 8 9 A B
    
7 8 9 10 11
C D E F
   
12 13 14 15
)
EVI-HD7V