Pan Motor - Sony EVI-HD7V Service Manual

1-7. Pan Motor

Parts information
The two types of screws (PSW2.6 x 6) are used in this unit.
. Part number: 3-669-607-91
+PSW2.6 x 6
Part name:
. Part number: 7-621-759-45
+PSW2.6 x 6 (In this illustration, this screw is indicated as PSW2.6 x 6 (Large).)
Part name:
m
. When replacing the pan motor, perform the Pan/Tilt adjustment in reference to Section 2-4.
. Tighten the following screws to the tightening torque as described below.
Tightening torque:
BSW M2 x 5: 0.2 ?0.02 N.m
PSW 2.6 x 6: 0.4 ?0.02 N.m
1. Remove the side cabinet. (Refer to Section 1-2-1.)
2. Remove the front bezel. (Refer to Section 1-2-2.)
3. Remove the camera cabinet (lower front/lower rear). (Refer to Section 1-2-3.)
4. Remove the camera cabinet (upper). (Refer to Section 1-2-4.)
5. Remove the camera block assembly. (Refer to Section 1-3-1.)
6. Remove the SY-359 board. (Refer to Section 1-4-4.)
7. Remove the fl exible fl at cable (22, 26). (Refer to Section 1-5.)
EVI-HD7V
1-23