Sony EVI-HD7V Service Manual page 18

1-4-2. DD-316 Board
n
When replacing the DD-316 board, perform the adjustment of camera in reference to Section 2.
1. Remove the side cabinet. (Refer to Section 1-2-1.)
2. Remove the front bezel. (Refer to Section 1-2-2.)
3. Remove the camera cabinet (lower front/lower rear). (Refer to Section 1-2-3.)
4. Remove the camera cabinet (upper). (Refer to Section 1-2-4.)
5. Remove the camera block assembly. (Refer to Section 1-3-1.)
6. Remove the VC-576 board. (Refer to Section 1-4-1.)
7. Remove the two screws.
8. Disconnect the two fl exible wiring boards from the
connectors (CN301 and CN851) on the DD-316 board,
then remove the DD-316 board.
9. To install, reverse the removal procedure.
1-12
Flexible
wiring board
Flexible
wiring board
CN851
DD-316 board
BSW
M2 x 5
CN301
EVI-HD7V