Board - Sony EVI-HD7V Service Manual

1-4-6. MDR-42 Board
n
When replacing the MDR-42 board, perform the Pan/Tilt adjustment in reference to Section 2-4.
1. Remove the side cabinet. (Refer to Section 1-2-1.)
2. Remove the front bezel. (Refer to Section 1-2-2.)
3. Remove the camera cabinet (lower front/lower rear). (Refer to Section 1-2-3.)
4. Remove the camera cabinet (upper). (Refer to Section 1-2-4.)
5. Remove the tilt motor. (Refer to Section 1-6.)
6. Disconnect the two fl exible fl at cables from the con-
nectors (CN501 and CN502) on the MDR-42 board.
7. Remove the two screws, then remove the MDR-42

board.

8. To install, reverse the removal procedure.
EVI-HD7V
MDR-42 board
PSW2.6 x 6
Flexible
flat cables
CN502
CN501
1-17