Sony EVI-HD7V Service Manual page 26

17. Disconnect the fl exible fl at cable (22, 26) from the
connector (CN501) on the MDR-42 board.
18. Remove the four screws (BTP2.6 x 8), then remove
the tilt stand portion in the direction of the arrow.
19. Pull out the earth cable and coaxial cable from the hole
of tilt chassis assembly.
20. Remove the three screws (PSW2.6 x 6).
21. Remove the tilt chassis assembly while pulling out the
two fl exible fl at cables (22, 26) from the two holes of
tilt chassis assembly.
1-20
Tilt stand portion
Tilt chassis assembly
CN501
MDR-42 board
Flexible flat
cable (22, 26)
BTP2.6 x 8
Tilt chassis assembly
Hole
Holes
Tilt stand portion
Coaxial cable
Earth cable
Flexible
PSW
flat cable
2.6 x 6
(22, 26)
BTP2.6 x 8
EVI-HD7V