Sony EVI-HD7V Service Manual page 82

4. Low speed operation check (Pan)
(1) Transmission at 8101062213FF (Receiving of debug command enabled)
Commands of 9041FF and 9051FF are returned to Response Window. (If this item continue perform-
ing after 2-4-2. Item 2, this may be omitted)
(2) Transmission at 8101060218140F0A060000000000FF (Moving of pan and tilt)
When command of 9041FF is returned to Response Window, the pan moves to the left end and tilt
moves to the HOME position. Therefore, wait until pan and tilt are stopped and 9051FF is returned.
(3) Transmission at 8101061300050a00FF (Pan low speed test)
When command of 9041FF is returned to Response Window, the pan moves to the right end at low
speed. After the moving is fi nished (It takes about 40 seconds), measurement result and error code are
returned. (Refer to Table 6).
Confi rm that the following items are in normal condition.
. Minimum speed:
. Maximum speed:
. Speed dispersion value: Less than 0350h
n
These data show the level of speed variation (shaking rate). When abnormal condition occurs, replace
a pan motor.
5. Low speed operation check (Tilt)
(1) Transmission at 8101062213FF (Receiving of debug command enabled)
Commands of 9041FF and 9051FF are returned to Response Window. (If this item continue perform-
ing after 2-4-2. Item 4, this may be omitted)
(2) Transmission at 810106021814000000000F0E0908FF (Moving of pan and tilt)
When command of 9041FF is returned to Response Window, the pan moves to the HOME position
and tilt moves to the lower end. Therefore, wait until pan and tilt are stopped and 9051FF is returned.
(3) Transmission at 8101061400010608FF (Tilt low speed test)
When command of 9041FF is returned to Response Window, the tilt moves to the upper end at low
speed. (Refer to Table 6) After the moving is fi nished (It takes about 10 seconds), measurement result
and error code are returned.
Confi rm that the following items are in normal condition.
. Minimum speed:
. Maximum speed:
. Speed dispersion value: Less than 0230h
n
These data show the level of speed variation (shaking rate). When abnormal condition occurs, replace
a tilt motor.
2-52
More than 0005h
Less than 0017h
More than 0005h
Less than 0017h
EVI-HD7V