Table of Contents
Advertisement
7-1-4. Adjusting Remote Commander
Use the adjusting remote commander to change the coefficient of the
digital signal processing or the EVR data.
The adjusting remote commander uses the remote commander signal
line (ECCP) to perform the bidirectional communication with the
camera microprocessor. The effect data of the bidirectional
communication must be written in the nonvolatile memory.
1. Using the adjusting remote commander
1) Connect the adjusting remote commander to the ECCP terminal
(MD-68 board CN101).
2) Adjust the HOLD switch of the adjusting remote commander to
"HOLD" (SERVICE position).
If it has been properly connected, the LCD on the adjusting remote
commander will display as shown in Fig. 7-6.
3) Operate the adjusting remote commander as follows.
¢ Changing the page
The page increases when the EDIT SEARCH+ button is
pressed, and decreases when the EDIT SEARCH- button is
pressed. There are altogether 16 pages, from 0 to F.
Decimal notation
Conversion value
0123456789
1011 12131415
Table. 7-1.
Hexadecimal
¢ Changing the address
The address increases when the FF (>) button is pressed,
and decreases when the REW (#4) button is pressed.
There are altogether 256 addresses, from 00 to FF.
* Changing the data (Data setting)
The data increases when the PLAY (B) button is pressed,
and decreases when the STOP (@) button is pressed.
There are altogether 256 data, from 00 to FF.
¢ Writing the adjustment data
The PAUSE button must be pressed to write the adjustment
data (F page) in the nonvolatile memory.
(The new adjustment data will not be recorded in the
nonvolatile memory if this step is not performed.)
4) Select page: 6, address: 00, and adjust the data to 01.
This releases the write protect of Page F, and enables the camera
section (Addresses 01 to BF of page F)
to be adjusted.
5) After completing all adjustments, turn off the main power supply
once.
2. Precautions upon using the adjusting remote
commander
Mishandling of the adjusting remote commander may erase the correct
adjustment data at times. To prevent this, it is recommended that all
adjustment data be noted down before beginning adjustments and
new adjustment data after each adjustment.
LCD Display of the Adjusting Remote Commander
7To1o7,.mm
Address
Page
Data
Normal mode/service
mode switching
START/
REC
REVIEW FOCUS
Page
change
=] L_] cama
a te ee eee ewe wns
EDIT SEARCH:
&
a"
RESETSCREENFRAME SLOW
[_] foo] [oe |
Data
change
Address
change
Fig. 7-6. Adjusting remote commander
RM-95 (J-6082-053-B)
Advertisement
Table of Contents
