Deployment Base Station Mounting Requirements - Nortel 7430 Deployment Manual

22
Once the Deployment Base has been placed in a testing position use the following steps:
1. Turn on the handset and activate the signal meter display in deployment mode.
2. Take a wireless handset off hook by pressing the
be taken with the handset off hook.)
3. Dial the handset number (1 or 2) of the opposite handset to establish a call. If the
technician is using the alternative audio source, the audio provided by this source
should be audible after pressing the
4. Place your hand over the top of the handset to simulate actual usage.
5. Move away from the Deployment Base while continually monitoring the Q-value and
sound quality. You have reached the coverage area border when:
a. The Q-value is lower than 52 and/or is significant fluctuating.
b. The sound quality begins to have mutes or heavy static.
6. Document the boundaries of the coverage area, move the Deployment Base to the
next position and continue for the remaining Base Station locations.

4.7 Deployment Base Station Mounting Requirements

The Deployment Base Station is intended to perform as a mobile substitute for a mounted Base
Station or Repeater. During deployment the technician will identify possible mounting locations.
The Deployment Base should then be positioned to face the same direction and as elevated as
close as possible to the same height as the intended mounting position.
The Deployment Base must be mounted vertically and right-side-up.
NN40110-304 1.1
key. (All measurements must
key.