Hardware Identification; Deployment Base Station - Nortel 7430 Deployment Manual

2.0 Hardware Identification

2.1 Deployment Base Station

The Deployment Base Station is only for use of deploying the Nortel Digital Mobility Solutions.
The Deployment Base Station provides 2 speech channels and supports a maximum of one
handset-to-handset conversation.
In the event a technician wishes to perform a deployment alone, the Deployment Base Station
supports the connection of an alternative audio source. When connected, the handset user has
the ability to verify the sound quality from Deployment Base. The input level is 0dBm nominal.
Two Deployment Handsets are subscribed to the Deployment Base from the factory. The
technician does have the ability to add and remove handsets when necessary without the need
for special software.
The Deployment Base Station is not approved for connection to any public network and is intend
only for use as a tool.
Illustrated below: 2.4 GHz Base Station
Power
Dimensions
Weight
Power supply:
The base station is supplied by a 9V/300mA adaptor. Current consumption is max. 130mA. It
is connected to the plug at the bottom of the base station (see fig. above).
Audio signal input:
The base station has an audio signal connection which can be used to connect an audio
signal from e.g. a CD player or MP3 player. This base station forwards the audio signal to the
handset when off-hook, allowing a single individual to perform a site survey.
Please note: You will need an audio cable with a 6 pole modular jack to connect the base
station with an audio source. Such a cable is supplied with the kit.
Audio in Registration button
(6.5 x 6.5 x 2.09
inches)
10.65 ounce
LED Power Indicator
(165 x 165 x
53mm)
(302g)
Digital Mobility Deployment Guide
11