Nortel 7430 Deployment Manual page 25

2. Place the Deployment Base Station in position 1 at a height of 6 to 8 feet/1,8-2,5m.
3. Measure the signal in a 45 degree angle towards the center of the area. Document the
boundary of the signal.
4. Proceed to point 2 and perform the same test. Document the boundary of the signal.
5. Placing the Deployment Base Station on the 2 boundary points will provide a good testing
location for permanent Base Station 1 and 2. Place the Deployment Base Station in
these locations; measure and document the boundaries of the coverage cell.
1 1
1 1
6. Mark where the boundaries of the permanent Base Station 1 and 2 intersect with the wall
being used as the base point.
7. Use these two locations (deployment points 3 and 4) as the points for placing the
Deployment Base Station to determine the location of permanent Base Station 3.
Figure B Figure B
Deployment Base Deployment Base
Final Base Final Base
3 3
3 3
Figure C Figure C
Deployment Base Deployment Base
Final Base Final Base
1 1 3 3
1 1 3 3
3 3
3 3
4 4
4 4
2 2
2 2
2 2
2 2
4 4
4 4
Digital Mobility Deployment Guide
25