Nortel 2211 User Manual page 36

Feature and function activation
To unmute a Push-to-Talk call:
To end a Push-to-Talk call:
To answer a telephone call
during a Push-to-Talk call:
36
1. Press the Unmute
The following prompt displays:
Unmute Two-Way Radio?
2. Press the Yes soft key to unmute the
call.
The prompt disappears after three
seconds if there is no response.
1. Press the Terminate
The following prompt displays:
Terminate Two-Way Radio?
2. Press the Yes soft key to end the call.
Push-to-Talk audio is immediately
stopped and the handset returns to
regular mode.
Only the current call is terminated for
this handset. When the next call period
starts, the handset is again in the receive
state.
You can rejoin a still-active session by
initiating a Push-to-Talk call.
An incoming telephone call can be answered
while in a Push-to-Talk call. To announce an
incoming call, the handset rings with a
low-volume ring and displays a system
message.
1. Press Power On/Start
The Push-to-Talk session is pre-empted.
2. After the telephone call is over, press
Power Off/End Call
on-hook.
soft key.
soft key.
Call.
as usual to go back