The States Of The Handset - Nortel 2211 User Manual

Your WLAN Handset 2211
K
Melody
In Service Tone
Line Indicator
Right/Up and
Left/Down arrows

The states of the handset

The WLAN Handset 2211 can be in one of the following states (see Table 2).
Table 2
The WLAN Handset 2211 states (Part 1 of 3)
State Description
Power off The handset is turned off. It is not registered with the Call Server.
Normally the handset enters the power-off state when the user
presses the
seconds when the handset is in the standby state. The batteries
can be recharged in the power-off state.
Standby This is the normal state when the handset is online but inactive. In
the standby state, the handset can receive calls and access the
User Option menu. To perform other operations, the handset must
be active (off-hook). The standby state uses less power than the
active (idle) state. The batteries can be recharged in the standby
state.
20
Your handset is downloading a new firmware file. You will be
unable to make or receive calls until the download is complete.
Do not power off the handset until the download icon
disappear.
A melody is played when the WLAN Handset 2211 is turned on
after the battery is fully recharged.
When the handset completes registration with the Call Server, it
plays the in-service tone.
The Line Indicator area displays the line current in use. Any
lines which are not idle or active (for example, if the line is on
hold or forwarded) will have a plus sign (+) sign in front of the
entry for that line.
These icons, on either side of the Line Indicator, are used in the
in-call menus to indicate "more items below or left" and "more
items above or right."
Power Off/End Call key for approximately two