Nortel 2211 User Manual page 34

Feature and function activation
period begins with the first transmission and ends when there has been no two-way
radio traffic on the channel for 10 seconds.
The Push-to-Talk mode controls the handset key pad during the call period. Therefore
it is not possible to use the key pad for any other functions. However, it is possible to
place and receive telephone calls.
To initiate a Push-to-Talk call:
Receive a Push-to-Talk transmission
Upon receiving a Push-to-Talk transmission, the "receiving alert" tone sounds and the
handset enters the receive state.
In this state the handset receives all conversations on the selected channel. The
display shows the current active channel, the caller ID of the current transmitter, and
an indication that the handset is receiving a broadcast transmission.
At the end of a transmission, the handset enters the waiting state where it monitors the
channel for up to 10 seconds and displays "Waiting" on the screen. If no other
transmission occurs within 10 seconds, the "end call" tone sounds and the handset
becomes idle.
34
1. Press the Push-to-Talk
right side of the handset.
The "start transmit" tone sounds within
2 seconds. The channel is active.
The display screen shows the current
active channel.
2. Speak into the handset's microphone.
All WLAN Handset 2211s that are
monitoring that channel hear the
transmission.
3. Release the Push-to-Talk
The "end transmit" tone sounds. The
handset enters the waiting state where it
monitors the channel for up to 10
seconds.
button on the
button.