Installation - Nortel 1110 Installation And Operation Manual

Page 198 of 630
LD 11 – Configure the IP Phone KEM (Part 5 of 5)
Prompt Response
KEY xx
KEMOFST <KEM>
<KeyOffset>
KEY xx

Installation

553-3001-368 Standard 26.00
IP Phone Key Expansion Module (KEM)
The IP Phone KEM mounts on the right side of an IP Phone 2002 or
IP Phone 2004. The IP Phone KEM snaps into the receptacle on the back of
the IP Phone using the desk-mount bracket and structural baseplate supplied
with the IP Phone KEM (see Figure 15).
August 2007
Description
Edit the IP Phone KEM key number specified by
PAGEOFST, where:
xx = the number of the key (for example, KEY 36)
Enter <CR> to keep the current setting.
Automatically calculates the IP Phone KEM key based
on the entered values. This prompt enables the system
administrator to enter a KEM number of 1 or 2 and a Key
Offset number from 0-23. Once entered, the KEY
prompt is prompted with the appropriate KEY value filled
in.
Enter <CR> to terminate data entry.
When values are entered for KEM and KeyOffset, the
KEY xx prompt displays, followed by KEMOFST prompt.
This loop continues until no values (<CR> only) are
entered at the KEMOFST prompt.
Note 1: Applies to an IP Phone 2002 if <CR> was
entered at the KEY prompt.
Note 2: Applies to an IP Phone 2004 with
KEM = 2, and where <CR> was entered at the KEY
prompt.
Edit the IP Phone KEM key number specified by
KEMOFST, where:
xx = the number of the key (for example, KEY 36)
Enter <CR> to keep the current setting.