V.25 bis Autodialer
INVPV
This message has one of three possible meanings:
• Any parameter set containing invalid characters
• Any parameter or parameter set containing no
valid (only ignored) characters
• Any parameter set containing an out-of-range
parameter
DIAL PARAMETERS
Table 11-1 lists and describes the parameters used in autodialing. The
memory available for dialing can hold up to 40 characters. Parameters
inserted for readability are not counted.
Table 11-1. V.25 bis Dial Parameters
Character
0 thru 9
* and #
:
W
>
=
<
P
T
&
;
Space, dash, paren-
thesis, period
V.25 BIS COMMAND AND RESPONSE DEFINITIONS
The following sections describe the commands used with the V.25 bis
autodialer and explain the responses received when each command is
executed.
11-4
DTMF and pulse digit
DTMF digit
Wait for dial tone
Wait for 2nd type of dial tone
Pause for 1 second
Pause for 3 seconds
Pause for programmed delay time
Pulse dialing
Tone dialing
Flash (go on hook) for ½ second
PARM separator
Parameters inserted for readability
V.3400
Function