Table of Contents
Advertisement
AT Commands
code is user programmable and can be set to any value from a single 0 to
any combination up to 99999999 using the %P=(desired code)
command.
Example: If the remote modem security code is 12345, the local modem
must include this code in the initialization string before the remote
modem responds.
Command
%P=
%P?
%P=D
%P=(blank)
* default
The %P=D command disables remote configuration. To enable remote
configuration, insert another security code.
Entering Remote Configuration %T=, &T
This mode of operation allows the modem user to view or modify the
option set of a compatible remote modem. Enter the %T= (security
code of remote) command to initiate remote configuration.
The modem is shipped from the factory with security code (blank). This
allows remote configuration by using (blank) as the security code.
Command
%T=
&T
Remote Configuration can also be specified by the dial command by
placing %T (password) after the dial digits (the equal sign is left off).
Example:
5-44
Sets security code to a value 0 to 99999999 entered after
the equal sign
Requests local security code to be displayed
Access for remote configuration is not possible when
security code is disabled
Clears security code *
This command followed by the correct security code
establishes remote configuration
Exits remote configuration
ATD 555-1212%T01234
Operation
Operation
V.3400
Advertisement
Table of Contents
