Force A Daily Test After The Following - DIGITIZE DDI-11E Installation & User Manual

Setting up the System
•
Ignore CID/SIA canned text if ACCT specific message exists. (Y or N) –
Upon receipt of a CID account, the SYSTEM 3505 will display and print the
"Canned" CID message when processing the account. If this selection is set
to Y, and there is a programmed text message for the CID account, then the
SYSTEM 3505 will not display and print the canned message when
processing the account. Set to N, the SYSTEM 3505 will display and print
both the canned message and the programmed message.
•
Are the following CID Event codes ALL RESTORE?
Some CID dialers do not send individual restores for reported Alarm or
Trouble conditions. However these dialers send a signal indicating all
conditions have now been restored. Various dialers use various event
type codes. If Y is selected for any or all three of these CID codes, then
when the SYSTEM 3505 processes these ID codes, it will check its entire
Alarm queue and restore all event type belonging to the same subscriber.
•
OPEN / CLOSE to Print?

4.5.6 Force a daily test after the following

•
DATA LOSS, i.e., Missed last signal (Y or N) – When the Dialer sends a
Data Loss zone, if that is in lieu of a daily test, then setting this to Y will force
a daily test after processing the missed last signal.
700289-0001 Rev. B 10/21
o 400 (Y or N)
o 401 (Y or N)
o 305 (Y or N)
o 400 (Y or N)
o 401 (Y or N)
o 402 (Y or N)
Digitize Inc.
The missed signal
4-15