Chapter 3, Installation will explain the steps to physically install a DDI-11E
Receiver.
3.1 Handling
3.1.1 Unpacking and Inspection
Before opening, inspect the shipping container for unusual damage. Unpack the
unit and inspect it for broken component leads and bent pins. Make sure each
component is tight in its socket. If your inspection reveals any physical damage,
retain the packing material and contact the carrier immediately. Each unit has been
thoroughly inspected prior to shipment.
3.1.2 Precautions
3.2 Parts of the DDI-11E
The following items are included with the DDI-11E:
1. DDI-11E Receiver
CD Disk containing D4 manual and EXd D4 configurator
2.
3. RS-232 Data Cable
4. Power Cable
5. Ground Wire
6. RS-232 Interface Card (either a Configurator Card or a Quad Serial Card)
700289-0001 Rev. B 10/21
DO NOT TOUCH the circuitry on the board during
CAUTION!!
installation as static discharge may damage components.
3 Installation
3-1
Need help?
Do you have a question about the DDI-11E and is the answer not in the manual?