DIGITIZE DDI-11E Installation & User Manual page 27

Setting up the System
Press "PRINT SET INFO" button for a list of CUSTOMERs.
After the operator enters the Customer number and presses the "Activate selctn
now" button, the printer will print the following message:
ADD CUSTOMER #
Press the FUNC button to move to the next field (24 HR= ). The message on the
display will change to:
"Daily tests every 24 hrs. or alternate time base. Alternate time xx.x applies to
all assigned.
Use ↑↓ to select 24 hrs or xx.x hrs. XX.X hrs represents a user defined global
value. For instance, if XX.X = 22.5 hrs and there are 100 dialers, when XX.X is
changed, the value will change at once for every dialer.
Press FUNC to move to the next field.
Y = Indicates the dialer tests in. N = No daily test.
Press the FUNC button to move the cursor to the next field (CONFIG) and the will
read:
"Unless this is a CID/SIA CUST, you must assign it to a CONFIG table needed to
Enter the number of the selected CONFIG table for this CUSTOMER.
Press the FUNC button to move to the next field (ADD/CHG/DEL) and the message
will read:
Use ↑↓ to select ADD, CHG or DEL mode. Press the "Activate selctn now" button to
save selection.
If ADD was selected, the printer will print the following message:
ADD CUSTOMER #
If CHG was selected, the printer will print the following message:
700289-0001 Rev. B 10/21
XXXX 24 HR TST= Y RST = Y CONF. # X
Note: If the user selects 24 HR=Y (Yes) and the dialer fails to
report in, an error message will be displayed on the screen and
printed by the thermal printer.
translate its zone codes"
"Select to ADD/CHG or Delete this CUST."
XXXX 24 HR TST= Y RST = Y CONF. # X
Digitize Inc.
4-11