Table of Contents
Advertisement
Control electronics
Control electronics
VTD-60.XX-K5C-S
VTD-60.XX-K5C-S
5
Installation
Dangerous movements in combination with drives or similar (see operating instructions of the relevant
product)
Check the control electronics' electrical equipment at regular intervals.
→ Ensure there are sufficient protective fixtures in the devices/systems, as actuating the motors in the wrong
way can lead to dangerous movements.
Possible remedial actions include:
DANGER
→ No lingering within the movement area of the devices or systems.
→ Ensure that the stability of the (protection) covers and housing is sufficient enough to resist the maximum
movement or rotation energy.
→ Before opening the control electronics or entering the danger zone, ensure all connected drives are safely
brought to a standstill and are secured against switching on again.
Impermissibly high load
Do not make any changes to the control electronics
→ Subjecting the control electronics to impermissible loads (e.g. impact, heat, overvoltage, mechanical load)
WARNING
might damage them. In this case, decommission the control electronics immediately and, before recommis-
sioning them, check that they are in proper condition.
Electromagnetic radiation
When integrating the control electronics into the system, the interaction may cause interference in terms of
electromagnetic compatibility (EMC). Ensure that the entire system is electromagnetically compatible.
WARNING
Health hazards for persons with pacemakers, metal implants, and hearing aids
For these people, access to the following areas is prohibited:
→ Areas in which electrical devices and parts are assembled, operated, or put into operation.
WARNING
→ Areas in which motor parts with permanent magnets are stored, repaired, or assembled.
Depending on the installation and operating conditions, the sound pressure level may exceed 70 dB(A)
Risk of noise-induced hearing loss
→ Take appropriate technical safety measures.
WARNING
→ Protect operating personnel with appropriate safety equipment such as hearing protection.
Hot surface – risk of burns
→ Ensure sufficient protection against accidental contact.
CAUTION
→ Ensure there is sufficient cooling.
Risk of cutting and crushing hazard when removing the control electronics from packaging and when
assembling
Carefully remove the control electronics from packaging, touching only the housing. Never subject to any
impacts!
CAUTION
→ Wear safety shoes and cut-resistant safety gloves.
Voltage
The control electronics are a built-in part without an isolating switch.
→ Only connect the control electronics to suitable electrical circuits. Note that the power supply units must be
suitably protected against secondary generator voltage.
CAUTION
→ When working on the control electronics, it is imperative that the system/machine is brought to a standstill
and secured against switching on again.
Electrostatic charging
Risk of damaging electronic components
→ Use ESD protective equipment during assembly and disassembly.
NOTE
Item no.: HAB 100177146 - 000 · ENU · Change 1.1· Approved 2023-02-21
Installation
21/37
Advertisement
Table of Contents
