Advertisement
Operating and Maintenance Instructions
4.0 Specification
Operating Environment
5.0 Installation
The 3-speed switched live EC fan controller - CN1102 – is a built-in appliance designed as a component part to be
installed in a clean, dry area within the user's equipment or within an enclosure that prevents access to live parts
and reduces the risk of contamination by ingress of dust and moisture.
There is one mounting hole on the rear of the housing that can accommodate a mounting screw with an 8mm
diameter pan head and the 2
It is recommended that the control signal cable is kept separate from mains supply wiring and shielded cabling can
be used if appropriate to prevent unwanted interference.
Exposure to vibration, high temperatures and direct sunlight should be avoided. The unit shall be installed according
to relevant safety guidelines and requirements included in the appropriate standards that form the basis of the low
voltage directive.
6.0 Mechanical Outline & Connection Detail
Dimensions
210-OMI13848_Iss5.docx
Product
Supply Voltage
Supply Current
Enclosure
Weight
Compliance
Table 1 - Specification
screw should use the DIN-rail release clip, or the controller can be DIN-rail mounted.
nd
Figure 1 - Dimensions of the unit
ORIGINAL INSTRUCTIONS
ebm-papst UK Ltd
Chelmsford Business Park Chelmsford Essex CM2 5EZ
Telephone: +44(0)1245468555 Fax: +44(0)1245466336
e-mail
sales@uk.ebmpapst.com
CN1102
115/230V, 1~, 50/60HzHz
Maximum 1.0A (Including fans)
IP00
100g
0°C to +60°C,
85% RH at 40°C maximum - non-condensing
Low voltage Directive 2014/35/EU
19/07/2022 09:04:36
Page 3 of 7
Advertisement
