Installation - ebm-papst VTD-60 K5SB Series Translation Of The Original Operating Instructions

Control electronics Control electronics
VTD-60.XX-K5SB VTD-60.XX-K5SB
5

Installation

Dangerous movements in combination with drives or similar (see operating instructions of the relevant
product)
Check the control electronics' electrical equipment at regular intervals.
→ Ensure there are sufficient protective fixtures in the devices/systems, as actuating the motors in the wrong
way can lead to dangerous movements.
Possible remedial actions include:
DANGER
→ No lingering within the movement area of the devices or systems.
→ Ensuring that the stability of the (protection) covers and housing is sufficient enough to resist the maximum
movement or rotation energy.
→ Before opening the control electronics or entering the danger zone, ensure all connected drives are safely
brought to a standstill and are secured against switching on again.
Impermissibly high load
Do not make any changes to the control electronics
→ Subjecting the control electronics to impermissible loads (e.g. impact, heat, overvoltage, mechanical load)
WARNING
might damage them. In this case, decommission the control electronics immediately and, before recommis-
sioning them, check that they are in proper condition.
Electromagnetic radiation
When integrating the control electronics into the system, the interaction may cause interference in terms of
WARNING
electromagnetic compatibility (EMC). Ensure that the entire system is electromagnetically compatible.
Health hazards for persons with pacemakers, metal implants, and hearing aids
For these people, access to the following areas is prohibited:
→ Areas in which electrical devices and parts are assembled, operated, or put into operation.
WARNING
→ Areas in which motor parts with permanent magnets are stored, repaired, or assembled.
Depending on the installation and operating conditions, the sound pressure level may exceed 70 dB(A)
Risk of noise-induced hearing loss
→ Take appropriate technical safety measures.
WARNING
→ Protect operating personnel with appropriate safety equipment such as hearing protection.
Hot surface – risk of scalding
→ Ensure sufficient protection against accidental contact.
CAUTION
→ Ensure there is sufficient cooling.
Risk of cutting and crushing hazard when removing the control electronics from packaging and when
assembling
Carefully remove the control electronics from packaging, touching only the housing. Never subject to any
impacts!
CAUTION
→ Wear safety shoes and cut-resistant safety gloves.
Item no.: HAB 100177146 - 000 · EN · Change· Release 2020-10-26
Installation
21/37