4 Permanent settings in programming mode
Setting the water
hardness
Energy-saving mode
26
The harder the water is, the more frequently the IMPRESSA needs
to be descaled. It is therefore important to set the water hardness
accurately.
The water hardness can be adjusted on a continuous scale between
1° dH and 30° dH.
E If you are using the CLARIS Blue filter cartridge and have acti-
vated it, it is not possible to set the water hardness.
Example: Proceed as follows to change the water hardness setting
from
to
16 °dH
25 °dH
Precondition:
ESPRESSO
O T Touch the P symbol for approximately 2 seconds until
appears on the display.
RINSE
g T Turn the Rotary Switch until
k T Press the Rotary Switch to enter the programme item.
16 °dH
g T Turn the Rotary Switch until
k T Press the Rotary Switch to confirm the setting.
appears briefly on the display.
OK
HARDNESS
O T Touch the P symbol to exit programming mode.
ESPRESSO
The energy-saving mode (Energy Save Mode, E.S.M.
prevent your machine from consuming power unnecessarily and to
actively save energy:
U
ENERGY w
U
Soon after the last preparation, the IMPRESSA stops heating
up. After about 5 minutes the message
played.
U
Before you can prepare a speciality coffee, steam or hot
water, the machine must heat up.
U
ENERGY -
U
All speciality coffees as well as hot water can be prepared
without having to wait.
U
Before you can prepare steam, the machine must heat up.
.
is displayed (example).
HARDNESS
25 °dH
(example)
is displayed.
is displayed.
©
) helps you to
is dis-
ENERGY w