Installing And Connecting The Device - Juniper SSG 500M Series Hardware Installation And Configuration Manual

Chapter 2

Installing and Connecting the Device

NOTE:
This chapter describes how to install an SSG 500M-series device in a standard
19-inch equipment rack and how to connect cables and power to the device. This
chapter includes the following sections:
"Before You Begin" on page 20
"Installing Equipment" on page 20
"Organizing Interface Cables" on page 22
"Chassis Grounding" on page 22
"Connecting Power" on page 22
"Powering the Device On and Off" on page 26
"Connecting the Device to a Network" on page 26
For safety warnings and instructions, refer to the Juniper Networks Security
Products Safety Guide. When working on any equipment, be aware of the hazards
involved with electrical circuitry, and follow standard practices for preventing
accidents.
19