AC Infinity AIRTITAN Series User Manual page 34

PROGRAMMING
T-SERIES
AUTO MODE (LOW HUMIDITY TRIGGER)
Pressing the up or down button sets the low humidity
trigger. The devices will activate if the probe's reading
meets or falls below this threshold.
Once triggered, the devices will gradually ramp up to
the level set in ON mode. If the probe's reading rises
above this trigger point, the devices will gradually
slow down to a stop or at the level set in OFF Mode.
You may set this trigger above the high humidity trigger to create a range in which the devices
are active.
This is typically used with devices like humidifiers to help raise the humidity when it gets too dry.
For example, if you set a low humidity trigger of 50%, then your device will activate when the
humidity falls to 50% or lower, and turn off when it rises above 50%. Products shown here may still
be in development.
Any of the four trigger points can activate while you are in AUTO Mode, even if you are viewing another trigger point.
Please set a trigger point to OFF if not in use, by holding down the up and down button. If there is a level set in OFF
Mode other than zero, the devices will run at that level when triggered to turn off.
34
LOW HUMIDITY
TRIGGER POINT
50
ON
32
LESS HUMID
OFF
100
MORE HUMID